Filter
Top Products
6-20 Removing and Replacing Parts
Formatter Cage Assembly
Figure 6-16 Removing the Formatter Cage Assembly
1 Print a Configuration Page. The information is necessary to
reconfigure the printer after you replace the Formatter.
2 Remove the rear right side cover (page 6-6). The Formatter Cage
Assembly is directly underneath.
3 Remove the captive screw and open the DIMM access door to
see if any DIMMs are installed. Remove and transfer any DIMMs
or EIO accessories if you replace the Formatter.
4 Remove the 5 screws around the Formatter cage.
5 Slide the Formatter toward the rear of the printer and remove it.
Note Using the Configuration Page you printed in step 1 above, reconfigure
the printer after replacing the Formatter. Be sure to reset the printer’s
page count (page 3-33).
For accessing DIMMs
EIO
accessory