Filter
Top Products
Chapter 7. PARAMETER SETUP
7 - 1 Parameter Setup
Parameter settings can be changed when the DCP552 is in the normal display mode.
When not in the normal display mode, press the DISP key to invoke it.
■ Selecting parameter settings groups
In the normal display mode, the keys listed in the table below can be used to select
settings groups and individual items in these groups.
Individual items in each settings group are listed below.
Variable parameter : PA01
Event configuration data : E01-t
PID parameters : P-1 in READY mode
Use P setting in the used PID group in modes other
than READY mode.
Setup data : C01
Constant value control data :ConSt when using FUNC + PID key
SP when using the PID key in constant value
control mode
■ Progression of individual items in parameter settings
The item codes for individual (specific) items are shown on display panel 1, their
set values are shown on display panel 2 and their mnemonic codes are shown on
the message panel.
Individual items are displayed in the vertical-horizontal matrix shown on page 7-3,
with matrix sizes varying according to settings group. The ↑ key, ↓ key, ← key
and → key are used to cycle through individual items.
The PARA key (valid for variable parameters and event configuration data), PID
key (valid for PID parameters and constant value control data) or the SETUP key
(valid for setup data) allow you to search for displayable items in ascending order
of item number.
ConSt
PA01
PA01
PA01
PA01
PA01
7-1