Filter
Top Products
8-4
■ Programming map
As shown below, a programming map consists of columns of segment numbers
and rows of program setting items.
In the program setting state, the items in the solid lines indicated by the segment
numbers and program setting items are displayed.
← key, → key : moves segments right and left
↑ key, ↓ key : moves segments up and down
The figure shows a programming map from the first to the 10th segment.
Programming map example:
*1 : Items up to segment 10 has been entered.
*2 : The event types of each event are listed below.
Event 1/2 : PV upper limit (event type setting 2)
Event 3/4 : time event (event type setting 1)
Event 5 : code event using two points
(event type setting 18, auxiliary setting 2)
Event 7 : time code event using two points
(event type setting 23, auxiliary setting 2)
Event 9 to 16: assigned to CH2 events (when setup C64 is set to 9)
*3 : These are settings used in each program and are shared by all segments.
Chapter 8. PROGRAM SETUP