Filter
Top Products
6-10
● DISP key function (when variable parameter PA03 is set to 1)
The DISP key is used to cycle through the displays in the following order:
Display F1, display F2, display F3, display F4, display F1.
When CH1 and CH2 are both in the fixed command control mode, the display
show the information shown in the figures below. When only one channel is in the
fixed command control mode, the displays provide the same information is shown
in the program run mode. Note, however, that channel time and remaining cycle
count are displayed as [-----].
● Display F1
● Display F2
● Display F3
When used in MANUAL mode, the number of digits available for output values
flashes.
● Display F4
Chapter 6. OPERATION