Filter
Top Products
System Features
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 – August 2005
Using the Last Number Dialed Feature
Page 233
chart on the previous page to determine which trunk is selected. The saved phone num-
ber is dialed.
Single line endpoints: While on a call or after selecting a trunk, hookflash and then
enter the Redial feature code (380). Refer to the chart on the previous page to deter-
mine which trunk is selected. The saved phone number is dialed.
Using the Last Number Dialed Feature
Use the following procedure to redial numbers at stations that are programmed to use the Last
Number Dialed feature.
To redial a number (last number dialed):
Inter-Tel endpoints: While on- or off-hook, press the button, or press the Spe-
cial button and enter the Redial feature code (380). Refer to the chart on the previous
page to determine which trunk is selected and which digits are dialed.
Single line endpoints: Lift the handset or hookflash. Then enter the Redial feature
code (380). Refer to the chart on the previous page to determine which trunk is
selected and which digits are dialed.
Redirect Call
The Redirect Call feature code is located under System/Devices and Feature Codes/Feature
Codes. The Redirect Call Feature (feature code 331) allows Inter-Tel endpoint users to route
ringing outside, intercom, and camped on calls to another station, hunt group, or outside num-
ber. Routing of the redirected call is still subject to trunk and toll restrictions. This feature pro-
vides these options in addition to the currently available options which allow the station user to
redirect calls to Voice Mail or Do-Not-Disturb.
The Redirect Ringing Call feature does not require premium features. Some specific aspects of
this feature are described below.
• If the user has an Executive Display, Professional Display, or Model 8560 endpoint, the
display will show a call menu option which reads SEND TO DEST. The user may
choose this option or enter feature code 331. The display then prompts the user to enter
the destination number directly or by scrolling through the IC directory.
• For non-display endpoints, calls are redirected using the feature code 331. This code is
entered, followed by the desired destination number.
• If the endpoint receiving the redirected call is a display endpoint, it will show EXT
XXXX FWD FROM EXT XXXX just as it does for a manually forwarded call.
• Calls may not be redirected back to the originating station. This will result in a message
on the display saying CALL FORWARDED TO SOURCE. For non-display endpoints,
the call will simply ring back at the station.
• Calls may not be redirected to restricted outside numbers, to stations in Do-Not-Disturb
mode, or to stations that are forwarded. Redirected calls will not follow call forwarding.
• Agent Help Request calls, queue callbacks, and recalls cannot be redirected (these types
of calls do not follow call forwarding).
• Calls cannot be redirected to another station’s mailbox, because redirected calls will not
follow forwarding.
• If the call is redirected to an unreachable destination, it will not be redirected and will
ring back at the original station.
REDIAL