Filter
Top Products
Administrator Procedures
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 – August 2005
Page 40 Trunk Programming
SION OPTION, press or the POLARITY REVERSE menu button for the polar-
ity-reversal supervision type. Or, press or the
VALID CALL menu button for
Valid Call timer supervision. Or, press or the
VALID + POLARITY menu button
for Valid Call timer with Polarity Reversal supervision. Then press or
ACCEPT
to continue.
Caller ID: To enable or disable Caller ID, press or the
CALLER ID menu but-
ton. When the display shows SET CALLER ID, press or
ON to enable the fea-
ture, or press or OFF to disable it. Then press or
ACCEPT to continue.
Hybrid Balance: To set the hybrid balance of the trunk to normal or short, press
or the
HYBRID BALANCE menu button. When the display shows HYBRID BAL-
ANCE OPTION, press or the
NORMAL menu button, or press or the
SHORT menu button. Then press or ACCEPT to continue.
DTMF/Dial-Pulse Signaling: To set the trunk for DTMF or dial-pulse signaling,
press or the
SIGNALING menu button. When the display shows ENTER SIG-
NALING OPTION, press or the
DTMF menu button, or press or the PULSE
menu button. Then press or ACCEPT to continue.
Trunk Group Number: To assign the trunk to a trunk group, press or the
TRUNK
GROUP
menu button. When the display shows ENTER TRUNK GRP EXTEN-
SION, enter the desired trunk group number using one of the methods described on
page 39.
Busy Trunk: To temporarily remove the trunk from service, press or the
BUSY
TRUNK
menu button. When the display shows MARK TRUNK BUSY, press
or the
ON menu button, or press or the OFF menu button. Then press or
ACCEPT to continue.
c. To exit, press or
ACCEPT to move backward through the prompts until you
reach the ENTER DATABASE OPTION prompt.
5. To Program A Trunk Group: Press or the TRUNK GROUP menu button. Then
program the trunk group, as follows:
a. The display shows ENTER TRUNK GRP EXTENSION. Enter the extension num-
ber of the trunk group to be programmed using one of the methods described on
page 39.
b. The display shows ENTER TRUNK GROUP OPTION. Select one of the following
options. To view the last three options on a display phone, press the arrow (<< or
>>) menu button at the bottom of the display.
Answer Access For Day Or Night Mode: To program the endpoint(s) that will
have answer access for this trunk group for day mode, press or the
ANS-
ACCESS DAY
menu button. To program for night mode, press or the ANS-
ACCESS NIGHT
menu button. When the display shows ENTER ENDPOINT
EXTENSION, perform the procedure described on the following page.
1.) Enter a endpoint extension using one of the methods described on page 39.
2.) The display shows the extension number and a Yes/No prompt. To include the
endpoint in the list, press or the YES menu button, followed by . Or, to
exclude the endpoint from the list, press or the NO menu button, followed
by .
3.) When the display returns to ENTER ENDPOINT EXTENSION, select
another extension number. Or, if finished programming the endpoint list, press
or ACCEPT to continue.
1
2
3
#
2
1
2
#
3
1 2
#
4
1 2
#
5
6
1
2
#
#
2
1
2
1
#
2
#
#