Filter
Top Products
Installing and Operating AN/DC and ANH-8/DC Systems
B-2
312410-A Rev 00
Filling Out the Quick-Start Worksheets
The install.bat script provides many options for configuring the router on a
network.
Use the following worksheets to organize your network information. Although
this section has many worksheets, you only need to fill out
• One Global Information Worksheet. This worksheet lists options common to
all synchronous interface configurations.
• One Router Protocol Worksheet. This worksheet lists specific options for RIP,
OSPF, or Static Route configurations.
• One Wide Area Protocol Worksheet. This worksheet lists specific options for
the Nortel Networks (proprietary) Point-to-Point Protocol (PPP), Frame
Relay, PPP Standard, and Switched Multimegabit Data Service (SMDS)
configurations.
We suggest the following procedure when filling out worksheets:
1.
Fill out the Global Information Worksheet completely.
(These options are the same for all synchronous interface configurations.)
2.
After recording your protocol selections on the Global Information
Worksheet,” fill out
only
the worksheets for these protocols in the Router
Protocol Worksheets” andWide Area Protocol Worksheets” sections.
For example, if you select RIP as your routing protocol and Frame Relay as
your wide area protocol, you need only fill out the worksheets pertaining to
these specific protocols.
3.
Go on to the sections Using the Quick-Start Commands” and Running
the Quick-Start Script.”
Note:
Because typical remote access uses a synchronous interface over a
WAN connection, this section lists only the options involved with a
synchronous configuration. When you configure a LAN interface, base your
decision on the information provided with each install.bat prompt.