Nortel Networks AN/DC Network Card User Manual


 
Starting the AN/DC and ANH-8/DC
312410-A Rev 00
3-17
Figure 3-13. Logging In to the Technician Interface and Mounting a
Volume
6.
Type the following command and press the Return key to begin the
Quick-Start procedure:
run install.bat
7.
Using your completed Quick-Start worksheet from Appendix B, enter the
appropriate network information as the prompts appear.
The router uses this information to configure its interface to the network.
Refer to Appendix B for sample Quick-Start screen output and for
information on using Quick-Start commands.
After the router creates and tests the configuration, your screen displays a
message saying that the Quick-Start installation is complete. Then the router
dynamically starts using the configuration information you entered.
Note:
To check the contents of the router’s local file system on the installed
Flash memory card, type
dir and press the Return key. The router software
image and config file should appear among the files listed.
Nortel Networks, Inc. and its Licensors.
Copyright 1992, 1993, 1994, 1995, 1996, 1997, 1998.
All rights reserved.
Login: Manager
Mounting new volume...
Device label:
Directory: 1:
New Present Working Directory: 1:
Welcome to the Backbone Technician Interface
[1:1]$
AN0024A