Filter
Top Products
Installing the AN/DC
312410-A Rev 00
1-9
Mounting the AN/DC on a Wall
When mounting the AN/DC on a wall, keep the following in mind:
• Make sure that the wall is at least 3/8 in. (0.96 cm) thick, and is made of
Sheetrock or wood.
• You need the following equipment before you start:
-- An electric drill
-- A Phillips screwdriver
-- Two wall-mount anchors
To mount the AN/DC on the wall:
1.
Drill two 5/16-in. (0.8 cm) holes in the wall 5-1/4 in. (13.34 cm) apart, at
least 3 ft. (0.915 m) off the floor.
2.
Insert one wall-mount anchor into each hole.
3.
Tighten the anchors with a Phillips screwdriver.
4.
Back the head of each screw out 1/8 in. (0.32 cm) from the wall.
5.
Hang the AN/DC on the wall by aligning the keyhole cutouts on the back
of the AN/DC with the protruding screw heads (Figure 1-5)
.