Nortel Networks AN/DC Network Card User Manual


 
Installing and Operating AN/DC and ANH-8/DC Systems
B-6
312410-A Rev 00
Enter OSPF MTU size selection
[1]:
1. Default
2. Ethernet size (Nortel Networks
Series 5 compatible)
3. User defined MTU
Enter OSPF interface type
selection [1]:
1. Broadcast
2. NBMA
3. Point-to-Point
4. Point-to-Multipoint
5. Point-to-Multipoint (STD)
Note:
When using a wide area
protocol other than Nortel Networks
Proprietary PPP, we suggest
selecting NBMA.
Enter decimal value in
seconds for Hello Interval
[10]:
Note:
This value must match all other
interfaces in the OSPF area for
connection to take place.
The script suggests the following
intervals:
Broadcast — 10 s
Point-to-Point — 15 s
NBMA — 20 s
Point-to-MultiPoint —10 s
Enter decimal value in
seconds for Router Dead
Interval [40]:
Note:
This value must match all other
interfaces in the OSPF area for
connection to take place.
The script suggests the following
intervals:
Broadcast — 40 s
Point-to-Point — 60 s
NBMA — 80 s
Point-to-MultiPoint (STD) — 40 s
Enter decimal value for
Router Priority [1]:
(For Broadcast, NBMA, or
Point-to-Multipoint)
Enter a router priority value. The
lower the value (above zero), the
higher the priority.
Note:
If you set the router priority to
zero (0), the router is not eligible to
become the designated router on
this particular network.
(continued)
OSPF Worksheet
(continued)
Requested Information Options Your Response