Filter
Top Products
Starting the AN/DC and ANH-8/DC
312410-A Rev 00
3-9
Continuing with Netboot
1.
Contact your network administrator to verify that the network is set up
for the Netboot procedure.
2.
Ask your network administrator (or refer to Appendix A) for the
interface configuration command to use in Step 3. Write the command
below for reference.
ifconfig _______________________
3.
Type the appropriate
ifconfig
command at the Diagnostic Monitor
prompt and press the Return key to configure the router’s interface to the
network.
Figure 3-6
shows a sample command.
Figure 3-6. Sample Interface Configuration Command
4.
Type the following command and press the Return key to verify the
configuration that you specified in Step 3:
getcfg
As Figure 3-7 shows, the
getcfg
command displays the location of the boot
image and the network configuration file, as well as the interface
configuration that you specified using the
ifconfig
command.
AN_DIAG>> ifconfig xcvr1 192.32.37.125 255.255.255.224
AN_DIAG>>
AN0001