Filter
Top Products
Installing and Operating AN/DC and ANH-8/DC Systems
3-10
312410-A Rev 00
Figure 3-7. Verifying the Interface Configuration
5.
If the configuration information is correct, continue to the next step.
Otherwise, reenter the correct
ifconfig
command. Contact your network
administrator if you need assistance.
6.
Type the following command and press the Return key to run the
diagnostic tests to completion and boot the AN:
reset
Or type boot
and press the Return key to boot the router without running the
diagnostic tests.
Figure 3-8
shows sample output from a boot
command.
Note:
The location of the image and configuration file is either local or
network. Local means that the an.exe or config file is stored on the router’s
local file system (Flash memory card). Network means that the an.exe or
config file is stored on a workstation located across the network.
Verify
AN_DIAG>> getcfg
Boot Options:
boot image=local
boot config=network
NetBoot Parameters:
XCVR1...IP=192.32.37.125, Mask=255.255.255.224
COM1....EZ-Install
COM2....EZ-Install
XCVR2...None
AN_DIAG>>
AN0065A