Filter
Top Products
312410-A Rev 00
Index-3
electronic enclosure rack
installing AN/DC in, 1-6
installing ANH-8/DC in, 2-7
physical specifications, 1-4
environmental specifications
AN/DC, 1-5
ANH-8/DC, 2-6
Ethernet
AN/DC interface connections, C-2
AUI port (ANH), C-7
AUI port (ANH-8/DC), 2-12
repeater connections (ANH-8/DC), C-5
repeater ports, C-4
UTP ports (ANH-8/DC), 2-13, 2-17, C-7
European operating specifications, D-1 to D-10
EZ Install
default settings, 3-15
requirements, 3-2
using, 3-5
F
flange brackets, installing
on AN/DC, 1-7
on ANH-8/DC, 2-7, 2-10
Frame Relay
settings, A-2
worksheet for, B-9
H
Hayes modem, 1-16, 2-23
HDLC encapsulation, A-2
heat exhaust, 1-5, 2-5
I
image, software
default boot location, 3-6
installing
AN/DC
in an electronic enclosure rack, 1-6, 1-7
on a flat surface, 1-6
on a wall, 1-9
preparing for, 1-1 to 1-5
ANH-8/DC
in an electronic enclosure rack, 2-7
on a flat surface, 2-6
on a wall, 2-10
preparing for, 2-1 to 2-6
cagenuts in electronic enclosure rack, 1-7
flange brackets
on AN/DC, 1-7
on ANH-8/DC, 2-10
interface configuration, 3-9, A-1 to A-3
interface connections
AN/DC
Ethernet, C-2
synchronous, C-2
Ethernet repeater ports, C-4
IP
address settings, A-3, A-4
connector setting, A-3
default setting, A-2, A-3
options for getting address, 3-3
ISDN BRI LED
AN/DC, 4-5
ANH-8/DC, 4-8
L
LAN. See Ethernet
LEDs, 4-4
AN/DC
BOOT, 4-4
CL (Collision), 4-5
DIAG, 4-4
ISDN BRI, 4-5
RLSD1 (Received Line Signal Detection 1), 4-5
RLSD2 (Received Line Signal Detection 2), 4-5
RUN, 4-4
RX (Receive), 4-5
ANH-8/DC
AUI Part, 4-7
Boot, 4-6
COL, 4-8
Col (Collision), 4-7
Data Carrier Detect (DCD), 4-7
Data Collection Module (DCM), 4-6
Fault, 4-6
ISDN BRI, 4-8