Nortel Networks AN/DC Network Card User Manual


 
Starting the AN/DC and ANH-8/DC
312410-A Rev 00
3-13
4.
Type the following command
and press the Return key to verify the
configuration that you specified in Step 3 (Figure 3-10)
:
getcfg
Figure 3-10. Verifying Directed Netboot Configuration
The Boot Options section displays the following information:
The IP address of the server where the software image and configuration
file reside
The pathnames of the software image and configuration file
5.
If the configuration information is correct, continue to Step 6. Otherwise,
reenter the correct
bconfig
command. Contact your network
administrator if you need assistance.
6.
Type the following command and press the Return key to run the
diagnostic tests to completion and reboot:
reset
Or type
boot
and press the Return key to boot the router without running the
diagnostic tests. Figure 3-11
shows sample output during the boot process.
Boot Options:
boot image=network
boot config=network
AN_DIAG>>
NetBoot Parameters:
host IP address=192.32.x.x
image pathname=
“/usr/anstartup/krnl_an.exe”
config pathname=
“/usr/anstartup/config”
XCVR1...IP=192.32.x.x, Mask=255.255.255.224
COM1....EZ-Install
COM2....EZ-Install
XCVR2...None
AN0020A