Filter
Top Products
Installing the ANH-8/DC
312410-A Rev 00
2-17
Connecting a Second Ethernet Interface UTP Cable
Complete these steps to connect a UTP cable to the back panel UTP-2 port.
1.
Attach a UTP cable to the back-panel RJ-45 connector (Figure 2-12).
Figure 2-12. Connecting a Second Ethernet Interface Cable
2.
Connect the other end of each cable to the communications device.
Note:
This section does not apply unless you have upgraded the ANH-8/DC
with a Second Ethernet Interface module.
COM 1
COM 2COM 3/Expansion
UTP-2
TX
RX
COL
Second Ethernet
UTP Cable Connector
AN0047B
RTN -VDC
-48VDC
-60VDC
1.5A