Filter
Top Products
Using Local Boot (the Quick-Start Procedure)
312410-A Rev 00
B-13
Running the Quick-Start Script
After you enter
run install.bat
, the AN/DC or ANH-8/DC progresses through the
Quick-Start script as follows:
1. The script begins prompting you for the initial Global Worksheet information.
2. After you select a router protocol option, the script prompts for specific
protocol information.
3. After finishing the router protocol configuration, the script requests a wide
area protocol selection.
4. After you select a wide area protocol, the script prompts for specific protocol
information.
5. After finishing the wide area protocol configuration, the script prompts for the
rest of the Global Worksheet information.
When the configuration is complete, the router runs through a test procedure for
the IP interface. When the test is complete, the following prompt appears:
Enter IP address of Site Manager workstation:
Obtain this information from your network administrator.