Nortel Networks AN/DC Network Card User Manual


 
Operating the AN/DC and ANH-8/DC
312410-A Rev 00
4-3
When power is supplied to the router, the following LED sequence should occur:
The POWER LED lights and remains on.
RUN, BOOT, and DIAG (or FAULT for ANH) LEDs light for approximately
1 second, then turn off, indicating that the router is functioning.
The RUN LED blinks for 1 to 3 minutes, indicating that the diagnostic tests
are running. (It blinks quickly during the initial 17-second memory test, then
slows down during the interface tests.)
The BOOT LED lights for 1 to 3 minutes, indicating that the diagnostic tests
were successful and the router is booting.
The RUN LED lights and the BOOT LED turns off, indicating that the router
is operational.
If the LEDs on the router light in this sequence, your installation is successful.
Contact your network administrator to verify that the router is now connected to
the network.
If the LEDs do not light in this sequence, your network administrator can refer to
Connecting BayStack AN and ANH Systems to a Network to help troubleshoot the
problem. If you need additional assistance, contact your local Nortel Networks
Technical Response Center.