Nortel Networks AN/DC Network Card User Manual


 
Operating the AN/DC and ANH-8/DC
312410-A Rev 00
4-11
AN/DC Reset Switch
On the AN/DC, the Reset button is located on the back panel of the AN/DC
(Figure 4-6)
. Labeled “RST,” it resides between the console port and the LED
labeled “RLSD2.”
Figure 4-6. AN/DC Reset Button
ANH-8/DC Reset Switch
On an ANH-8/DC, the Reset button is set inside the front panel (Figure 4-7).
Figure 4-7. ANH-8/DC Reset Button
Note:
The Link and Partition LEDs for repeater Ports 1-8 flash when you reset
the ANH, whether or not a port has attached cables.
COM 1
COM 2
RLSD1RLSD2
CONSOLE
U
L
U
L
TX
RX
CL
UTP
XCVR
Reset Button
RST
AN0014B
RTN -VDC
-48VDC
-60VDC
1.5A
Reset
Partition
Link
12345678
1234 5678
Power
Fault
Console
Boot Run DCM AUI Part
DCD1 DCD2 <LAN> Col
AUI
MDI-X/MDI
MDI-X
Reset
AN0055A