Filter
Top Products
Starting the AN/DC and ANH-8/DC
312410-A Rev 00
3-15
Continuing with Local Boot
You need to use both the Diagnostic Monitor and the Technician Interface to local
boot the AN. Before starting the Local Boot procedure, ask your network
administrator for assistance in completing the Quick-Start worksheets in
Appendix B.
To use the Local Boot feature:
1.
Contact your network administrator to verify that the network is set up
for the Local Boot procedure.
2.
At the Diagnostic Monitor prompt, type the following command and
press the Return key to configure the router to use its local
config
file:
bconfig config local
3.
Type the following command and press the Return key to run the
diagnostic tests and boot the AN:
reset
Or type
boot
and press the Return key to boot the AN without running the
diagnostic tests.
Figure 3-12
shows sample output during the local boot process.