Filter
Top Products
Installing and Operating AN/DC and ANH-8/DC Systems
3-14
312410-A Rev 00
Figure 3-11. Directed Netboot
After the router reboots, it gets a configuration file from a TFTP server and
loads the software image from the local file system.
The router starts bridging and routing traffic.
7.
When you boot the router, its LEDs flash in a particular order. To
interpret the LED sequence and troubleshoot any potential problems,
refer to Chapter 4.
After connecting the router to the network, you can replace the console connection
with a modem connection to enable remote dial-in access.
Note:
If the router cannot find a software image or configuration file via
Directed Netboot, it attempts to Local Boot once. If both attempts fail, the AN
Diagnostic Monitor Login prompt (
AN_DIAG>
) appears on the console. In this
case, you or your network administrator must troubleshoot the problem.
Booting Access Node...
Starting OS kernel for network boot...
Attempting Directed Netboot.
Directed Netboot using active IP interface XCVR1.
Retrieving config 'config' from network. done
Retrieving image 'krnl_an.exe' from network......done
Nortel Networks, Inc. and its Licensors.
Copyright 1992, 1993, 1994, 1995, 1996, 1997, 1998.
All rights reserved.
Login:
AN0070A