Nortel Networks AN/DC Network Card User Manual


 
Installing and Operating AN/DC and ANH-8/DC Systems
3-4
312410-A Rev 00
1.
Position the card with the label facing up and the INSERT arrow
pointing toward the card receptacle.
2.
Insert the card into the receptacle.
Figure 3-2
shows how to insert the Flash memory card in an AN/DC that does
not have a Flash memory card protector installed.
Figure 3-3
shows how to insert the card in an ANH-8/DC.
3.
Gently push the card until it fits snugly into place.
If the card is new, and you did not obtain it from Nortel Networks, you must
format the card before attempting to write to it. You can format the card using Site
Manager software or the
format command available with the Nortel Networks
Technician Interface. (Refer to Using Technician Interface Software for
instructions.)
Figure 3-2. Inserting the Flash Memory Card in the AN/DC Receptacle
Caution:
If you attempt to boot without the Flash memory card inserted, the
router will not operate.
RUN
BOOT
DIAG
POWER
AN0015A