Filter
Top Products
Starting the AN/DC and ANH-8/DC
312410-A Rev 00
3-11
Figure 3-8. Netboot
7.
When you boot the router, its LEDs flash in a particular order.
To interpret the LED sequence and troubleshoot any potential problems, refer
to Chapter 4.
After connecting the router to the network, you can replace the local console with
a modem connection to enable remote dial-in access.
Note:
If the router tries to Netboot and cannot find a software image or
configuration file, it attempts to Local boot once. If both attempts fail, the AN
Diagnostic Monitor Login prompt (
AN_DIAG>>) appears on the AN console. In
this case, you or your network administrator must troubleshoot the problem.
AN_DIAG>> boot
Booting Access Node...
Nortel Networks, Inc. and its Licensors.
Copyright 1992, 1993, 1994, 1995, 1996, 1997, 1998.
All rights reserved.
Login:
Starting OS Kernel for network boot...
Attempting Netboot on XCVR1
Attempting EZ-Install on COM1, using Wellfleet Pt-to-Pt
Attempting EZ-Install on COM2, using Wellfleet Pt-to-Pt
IP interface active on XCVR1, attempting BOOTP
Received BOOTP response from server 192.32.3.9 on XCVR1
Retrieving config 'config' from network. done
Found image '1:an.exe' on local file system...booting
Image is in compressed format... decompressing
AN0018A