Filter
Top Products
DM925™ Digital Mailing System Operating Guide
SV62207 Rev. B 6-5
Connecting
Your
Po
stage
Meter to an
Analog
Phone Line
Which connector do I use?
Internal Analog Phone Line Connector - Use the internal analog modem
to connect directly to an analog phone line.
If your mailing system is not located near an analog phone line and you
ne
ed to remove the control center when you perform feature updates or
add postage, refer to Connecting Your Postage Meter to a Remote Analog
Line in this section.
Connecting Your
Mailing System
to a Remote
Analog Phone
Line
If you need to connect to an analog phone line that is not located near your
mailing system, you can remove the IntelliLink® Control Center and move it
to a location near the analog phone line. At the remote location, plug one
end of the AC Adapter (P/N 1C85005) into the back of the control center
and the other end into an AC outlet.
To remove the control center and move it to another location:
1. Turn off the power to the mailing system.
2. Pull the blue lever at the right of the control center towards you.
3. Slide the control center forward to remove it.
4. Take the control center to where the analog phone line is.
5. Connect the telephone cord (AWG 26) from the internal analog connec-
tor to the analog telephone line.
6. Connect the A/C Adapter (P/N 1C85005) to the back of the control cen-
ter and plug it into an AC outlet.
7. Add or check your postage
fun
ds as described in Checking
Your
Postage By Phone® Meter
Payment System Account Bal-
ance in this ch
apter.
8. Unplug the telephone cord and
the
A/C Adapter.
9. Reinstall the IntelliLink® Con-
trol Center by sliding it into the
docking st
ation on top of the
mailing system until you hear it
click into place.
10. Turn the power back on.
2
Internal Analog Phone
Line Connector
Use this to connect
directly to an analog
phone line
AC Adapter
Plug
Internal
analog line