Filter
Top Products
DM925™ Digital Mailing System Operating Guide
SV62207 Rev. B 1- 3
What You Need
to Know
Since your postage meter (Postal Security Device) is licensed by the United
States Postal Service (USPS), you must follow a few basic requirements.
USPS
Requirements
• Mail must have the correct date and postage amount in the meter
stamp.
• Metered mail must bear the ZIP Code location of the post office where
the
postage meter (Postal Security Device) is registered.
• If you move to another ZIP Code location, you must update the ZIP
Code.
You can do this by calling Postage by Phone®.
• Each time you refill your postage meter (Postal Security Device) through
the
modem or LAN, the Postage By Phone® Meter Payment System
computer automatically performs a postal inspection. If the postage
meter in your mailing machine has not detected a modemor LAN refill
transaction at certain intervals, the message “Inspection Required”
appears on the main screen of the IntelliLink® Control Center. (The sys-
tem will then prompt you to connect to Pitney Bo
wes and perform an
inspection.)
• The postage tape you use must meet USPS specif
ications.
Safety
Requirements
Read all instructions before you attempt to operate the machine. Use
the equipment only for its intended purpose.
• Use only Pitney Bowes approved supplies,
in particular aerosol dusters.
Improper storage and use of aerosol dusters or flammable aerosol dust-
ers, can cause an explosive
-like condition that could result in a personal
injury and/or property damage. Never use aerosol dusters labeled flam-
mable and always read instructions
and safety precautions on the
duster container label.
• Use the power cord supplied with the machine and plug it into a properly
gro
unded wall outlet located near the machine and easily accessible.
Failure to properly ground the machine can result in severe personal
injury and/or fire.
• The power cord wall plug is the p
rimary means of disconnecting the
machine from the AC supply.
• Do not remove the power cord's ground pin and do not use a ground
ada
pter.
• Make sure the area in front of the power outlet is free of obstruction.
• DO NOT route the power cord over sharp edges or trap it between
pieces of fu
rniture. Make sure there is no strain on it.
• To reduce the risk of fire or electrical
shock, DO NOT attempt to remove
covers or disassemble the equipment. The housing encloses hazardous
parts. If any components are dropped or otherwise damaged, report
such damage to your Pitney Bowes customer service representative.
• Keep fingers, long hair, jewelry, neck tie
s, and loose clothing away from
moving parts at all times.
• When removing jammed material, avoid using too much force to prevent
per
sonal injury and damaging equipment.
• To prevent overheating do not cover system vent openings.
WARNING! Follow normal safety precautions for all office equip-
ment whenever using your mailing system.