Filter
Top Products
9 • Maintaining and Updating
9 - 4 SV62207 Rev. B
E-Z Seal
®
Sealing
Solution
Maintenance
Your mailing system displays a message telling you when your E-Z Seal®
Solution is running low. When you receive this message, your system can
still seal approximately 50 envelopes.
Filling the
Moistener Bottle
1. Open the moistener cover
and lift out the flap moist-
ener bottle..
2. Remove the cap from the
bot
tle.
3. Add enough E-Z Seal® to
bring the
level up to the
bottom of the fill cap.
4. Replace and tighten the
cap and r
eturn the bottle to
its original position.
5. Close the main cover.
Cleaning the
Moistener Brush
1. Move the tape lever to the
up position and open the
side door.
2. Pull the brush mecha-
nism forward and hold as
shown at right (A).
3. Remove the bruse case
as sho
wn in the illustra-
tion at right (B).
4. Rinse the brush under
cold water
, separating the
bristles to remove excess
glue and deposits.
CAUTION:
• Pitney Bowes recommends using E-Z Seal® Solution
b
ecause it helps keep your moistener tank clean and
improves sealing efficiency. To order E-Z Seal® Solution,
refer to Chapter 11, Supplies and Options in this guide.
• Do not overfill the E-Z Seal® bottle.
• Make sure you do not spill any solution
in the tape well. If
the tape gets wet, it can warp and cause a jam.
Moistener
Bottle
Moistener Cover
!
"