Filter
Top Products
4 • Running Mail
4-34 SV62207 Rev. B
Changing the Date
1. If you are printing the date correction on an envelope and if the enve-
lope is sealed, press the Seal key
and select Sealer Off. If you are print-
ing on a tape, go to step 3.
2. Turn the piece of mail around 180 degrees so that the meter stamp is in
the
lower left corner as shown here. Then, place the envelope on the
feed deck with the flap facing down.
3. Press the Mode
key and select Key In Postage.
4. Enter the 00.00 for the postage value using the numeric keys and press
Enter
.
5. Press the Men
u key and then select Meter Stamp Options.
6. Select the Date op
tion and make the appropriate selection.
7. Follow the prompts on the main screen. Press Enter wh
en complete.
8. Press the St
art key. If you are printing a tape, press the Tape key. The
date correction prints on the envelope as shown below.
9. If you print a tape, apply the tape to the envelope below the existing
meter st
amp.
Clearing the
Batch
Count
If you keep track of the number of pieces of mail you process for each job
or mail run, you may want to clear the batch count at the end of a run or just
before starting a new run. The batch count appears on the display in the
lower right corner.
To clear the batch count:
1. Press the Funds key
.
2. The “View Funds” screen appears.
3. Press the right arrow key to clear the batch count.
4. If you have specified that a supervisor password must be entered to
clear th
e batch count, you are prompted to enter the password now.
5. Enter the password and press the Enter ke
y.
00 30
00 37
00 37
00 00
JULY 03,2002
00 37
9