Filter
Top Products
5 – Non-Interactive Mode Commands
Non-interactive Commands
SN0054621-00 E 5-21
A
For information on the interactive version of this command, see “Configure iSCSI
Settings (CLI Options -n and -nh)” on page 4-24.
-nc
(Display Neighbor Cache)
To display the neighbor cache (IPv6 only), enter the -nc command as follows:
-nc <hba_port_inst>
For information on the interactive version of this command, see “Display Neighbor
Cache (IPv6) (CLI Option -nc)” on page 4-33.
-netconf
(Configure IPv6 Settings)
To configure the network settings, enter the -netconf command as follows:
-netconf <hba_port_inst> [-IP <IP Address>] [-IPNM <Subnet Mask>]
[-IPGW <Gateway IP Address>]
Where:
Setting the IP address, subnet mask, or gateway turns off DHCP address
resolution for the IP configuration, if it is on.
For information on the interactive version of this command, see “Configure IPv6
Settings (CLI Options -netconf, -netconf6, -isns, -isns6, -ip, and -nc)” on
page 4-27.
KeepAliveTO KATO 0–65535
Large_Frames LRGFRM
on or off
a
MaxBurstLen MBL 0–65535
MaxOutstandingR2T MOR2T 0–65535
a
Not for QLA4010
IP <IP Address> = Sets the IP address of the HBA.
IPNM <Subnet Mask> = Sets the subnet mask of the HBA.
-IPGW <Gateway Address> = Sets the gateway.
-DISN4 = Disables IPv4 network setup.
-IPv4DHCP = Sets DHCP on.
Table 5-3. HBA Parameters (Continued)
Configuration Name Configuration Alias Value