Filter
Top Products
5 – Non-Interactive Mode Commands
Non-interactive Commands
5-22 SN0054621-00 E
S
-netconf6
(Configure IPv6 Settings)
To manually configure the IPv6 network settings, enter the -netconf6 command
as follows:
-netconf6 <hba_port_inst> [-IP <IPv6 Address>] [-IPNM <Subnet
Mask><IPv6>] [-IPGW <Gateway Address>]
Where [option] includes the following:
Setting the IP address, subnet mask, or gateway turns off DHCP address
resolution for the IP configuration, if it is on. Some examples of usage follow.
IP <IP Address> = Sets the IP address of the HBA.
-IPNM <Subnet
Mask>
= Sets the subnet mask of the HBA.
-IPGW <Gateway
Address>
= Sets the gateway.
-DISN4 =
Disables IPv4 network setup
a
a
Mutually exclusive with the other IPv4 commands
-IPV4DHCP =
Set DHCP ON
b
b
Mutually exclusive with -IP/-IPNM/IPGW
-IP = Set IP Address
-IPNM = Set IP Netmask
-IPGW = Set IP Gateway
-DISN6 =
Disable IPv6 Network Setup
c
c
Mutually exclusive with -IPLLA/-IPLL
-IPLLA =
Set Local link Address Automatically
d
d
Manual or automatic—mutually exclusive
-IPLL =
Set Local link Address Manually
d
-IPR01A =
Set IPR0 and IPR1 Automatically
e
e
Manual or automatic—mutually exclusive
-IPR0 =
Set Routable Address 0 Manually
e
-IPR1 =
Set Routable Address 1 Manually
e
-IPRRA =
Set Router Address Automatically
f
f
Manual or automatic—mutually exclusive
-IPRR =
Set Router Address Manually
f
Table Footnotes