Filter
Top Products
4 – Interactive Mode Commands
Port Level Info & Operations Menu
4-40 SN0054621-00 E
S
Add a Target
(CLI Option -pa)
Select the Add a Target option to add a new target to the current working adapter.
When prompted, type the following information for the new target; the parameters
are displayed one at a time:
TGT_iSCSI_Name (target iSCSI name)
TGT_Port (target port)
TGT_TargetIPAddress (target IP address)
If you do not enter the TGT_iSCSI_Name, the default is an empty string. If you do
not enter the TGT_Port number, the default is 3260.
Disable a Target
Select the Disable a Target option to disconnect the target and disable future
connections until you re-enable it. The target remains in the HBA database.
Enable a Target
Select the Enable a Target option to re-enable the target and re-establish the
connection, if possible.
Configure Target Authentication Menu
The iSCSI HBA firmware uses the challenge handshake authentication protocol
(CHAP) as an authentication mechanism between the iSCSI initiators (QLA4xxx
HBA ports) and the targets to which they are attached. Authentication can be
disabled or enabled for a specific target or for all targets attached to the QLA4xxx
HBA port.
To configure target authentication (CHAP):
1. If you have not already, specify the HBA port whose settings you want to
view or change by typing the number for Select HBA Port, and then
pressing ENTER.
SANsurfer iSCSI HBA CLI lists all iSCSI HBA ports.
2. Type the number for the HBA port whose settings you want to change, and
then press ENTER.