Filter
Top Products
5 – Non-Interactive Mode Commands
Non-interactive Commands
SN0054621-00 E 5-31
A
-t <hba_port_inst> [Target ID]
If you only specify the <hba_port_inst> parameter, SANsurfer iSCSI HBA CLI
displays target information for all targets on the specified HBA port. If you specify
the optional parameter [Target ID], SANsurfer iSCSI HBA CLI displays
information on the specified target only. This includes both persistent and dynamic
targets.
For information on the interactive version of this command, see “Display Target
Information (CLI Option -t)” on page 4-37.
-tc
(Configure Target Parameters)
To set target parameter settings, use the -tc command. For a list of target
parameters you can configure, enter the following:
-tc <hba_port_inst> < Target_ID > <config_name | config_alias>
<value> <config_name | config_alias> <value>
For information on the interactive version of this command, see “Configure Target
Parameters (CLI Option -tc)” on page 4-39.
-tp
To see information stored in Flash memory about persistent targets, enter the -tp
command. If you enter only the HBA port instance number, SANsurfer iSCSI HBA
CLI returns information for all targets of that HBA port instance. If you enter the
optional Target ID, SANsurfer iSCSI HBA CLI returns information for that target
only, for example:
-tc <hba_port_inst> <Target_ID>
There is no corresponding interactive command for this function.
For a list of target parameters, see Appendix C Target Parameters.
-ts
To see summary information about both persistent and non-persistent targets,
enter the -ts command as follows:
-ts [hba_port_inst] [Target_ID]
There is no corresponding interactive command for this function.
-ver
(Display Program Version Information)
To view the SANsurfer iSCSI HBA CLI program version, enter the -ver command
as follows: