Filter
Top Products
5 – Non-Interactive Mode Commands
Non-interactive Commands
5-26 SN0054621-00 E
S
-px
To unbind all persistent targets on the HBA, enter the -px command as follows:
-px <hba_port_inst>
-r
(Update ROM Image)
For information on ROM image file names, refer to Appendix E Downloadable File
Names.
Be sure to select Save changes and reset HBA afterwards; otherwise, the
change will not take effect.
Type the following command to update the specified HBA’s ROM:
-r <hba_port_inst> <File Name>
The <hba_port_inst> parameter is the HBA instance to update. The <File Name>
parameter indicates the file containing the ROM image to upload.
For information on the interactive version of this command, see “Update ROM
Image (CLI Option -r)” on page 4-14.
-rdf
Enter the -rdf command to restore the specified HBA port’s firmware values to
the factory default values:
-rdf <hba_port_inst>
Issuing this command resets the HBA.
There is no interactive command for this function.
CAUTION!
Before attempting to update the ROM image contact QLogic Customer
Support.
Before updating the ROM image, ensure that no I/O processes are
running.
An administrator must take necessary actions to ensure changes will be
fully recognized by the operating system (reboot, flush cache, sync disk,
and so forth).
A ROM update and reset will be performed that requires that all
applications accessing impacted LUNs must be shut down.
Any impacted systems must be unmounted.