Filter
Top Products
4 – Interactive Mode Commands
Port Level Info & Operations Menu
SN0054621-00 E 4-21
A
Link Local Address : fe80::2c0:ddff:fe08:5a13
IPv6 Local Address State : Valid (0x5)
IPv6 Address 0 : Source Address Not Valid
IPv6 Address 1 : Source Address Not Valid
IPv6 Default Router : Router Address Not Valid
IPv6 Port Number : 3260
IPv6 Router Adv Link MTU : 0 bytes
iSNS : Disabled.
Configure IP Settings
(CLI Option -ipdhcp)
Select the Configure IP Settings menu to enable or disable the following
features:
Enable IPv4
DHCP to obtain IPv4 Network Information
Enable IPv6
Obtain Link Local Auto
Obtain Routable Address Auto
Obtain Router Address Auto
IPv6 Default Router IP Address
You are prompted to turn on or off each feature; the current state is shown at the
end of the prompt. For example, the following prompt indicates that the router
address is not obtained automatically:
Obtain Router Addr Auto [off] :
To change this setting, type on, and then press ENTER (be sure to turn off the
CAPS LOCK key; entries are case sensitive). If you do not want to change this
setting, press ENTER.
iSNS Settings
(CLI Option -isns)
By default, iSNS is disabled. Use iSNS when extended discovery management
capabilities (for example, notifications, access management, and configuration)
are required, such as in larger storage networks.
To enable iSNS, type on at the Use iSNS: [off] prompt, and then press
ENTER. You are prompted to enter an iSNS IP address.