Filter
Top Products
4 – Interactive Mode Commands
Port Level Info & Operations Menu
SN0054621-00 E 4-37
A
4. For each submenu, save the changes by typing the number for the Save
Target/CHAP changes option, and then pressing ENTER.
5. Type the number for the Refresh option, and then press ENTER. If you do
not select this option, your changes will not be visible in SANsurfer iSCSI
HBA CLI.
List Targets
(CLI Option -t)
To list all targets connected to the current working adapter, type the number for
the List Targets option, and then press ENTER. The following information is
displayed for each target:
Target ID (target ID of this device as assigned by the QLogic tool)
HBA number
IP (IP address of the target)
Port instance (port ID for iSCSI devices, as defined by the iSCSI standard)
iSCSI name (target iSCSI name, as defined by the iSCSI standard)
Alias (target iSCSI alias name, as defined by the manufacturer software)
State (of the target session connection). Session states include:
Unassigned
No Connection
Discovering
Not Saved
No Session
Session Active
Logged out
Session Failed
Unknown
Display Target Information
(CLI Option -t)
Select the Display Target Information option to view the same information
shown for the List Targets option. At the Enter a Target ID: prompt, type
the ID of the target for which you want to see more detailed information, and then
press ENTER.
The following shows an example of target information:
Target ID: 2 hba_no: 5 IP: 10.14.64.154 Port: 3260 TGT Instance #: 2
ISCSI Name: iqn.1987-05.com.cisco:00.28182218624e.chap4
Alias: chap4
State: Session Active
TGT_iSCSI_Name :
iqn.1987-05.com.cisco:00.28182218624e.chap4
TGT_Target_ID : 2(*)