Filter
Top Products
5 – Non-Interactive Mode Commands
Non-interactive Commands
SN0054621-00 E 5-5
A
Where:
If HBA DHCP is enabled (see “-ipdhcp (Configure IP Settings)” on page 5-16),
modes 1–3 are allowed. If HBA DHCP is not enabled, bootcode DHCP is not
allowed. This mode is not supported for QLA4010 HBAs. This mode is not active
for the PPC.
For IBM cards, the following modes are available:
For information on the interactive version of this command, see “Set BIOS/UEFI
[or FCode] Mode (CLI Option -bootcodemode)” on page 4-35.
-c
(Display Configured Port Settings)
To view the configured settings for the port, enter the -c command as follows:
-c [hba_port_inst]
When you specify a port instance, information for only that HBA is shown. When
you do not specify a port instance, information for all HBA ports in the system is
shown.
For a list of HBA settings, see “Display Configured Port Settings (CLI Option -c)”
on page 4-22 and Appendix C Target Parameters.
-ch
(HBA Information)
To display the HBA’s configured settings, enter the -ch command as follows:
-ch [hba_port_inst]
When you specify a port instance, information for only that HBA is shown. When
you do not specify a port instance, information for all HBA ports in the system is
shown.
1 = Disabled
2 = Manual mode
3 = DHCP–Root path
4 = DHCP Vendor ID
5 = DHCP-Auto
6 = Auto
7 = System Mode
NOTE:
Bootcode DHCP is not allowed for QLA4010 HBAs.