Filter
Top Products
5 – Non-Interactive Mode Commands
Non-interactive Commands
5-6 SN0054621-00 E
S
For a list of HBA settings, see Table 5-3 on page 5-19. For a complete list of HBA
parameters, see Appendix C Target Parameters.
For information on the interactive version of this command, see “HBA Information
(CLI Option -ch)” on page 4-12.
-chapmap
(Display Targets Using CHAP Entries)
To display the map of targets to CHAP table entries, enter the -chapmap
command as follows:
-chapmap <hba_port_inst>
For information on the interactive version of this command, see “Display Targets
Using CHAP Entries (CLI Option -chapmap)” on page 4-41.
-cpbootcode
(Clear Primary Boot Target Information)
To clear the primary boot target and LUN, enter the -cpbootcode command as
follows:
-cpbootcode <hba_port_inst>
For information on the interactive version of this command, see “Clear Primary
Boot Target Information (CLI Option -cpbootcode)” on page 4-36.
-csbootcode
(Clear Secondary Boot Target Information)
To clear the secondary boot target and LUN, enter the -csbootcode command
as follows:
-csbootcode <hba_port_inst>
For information on the interactive version of this command, see “Clear Secondary
Boot Target Information (CLI Option -csbootcode)” on page 4-36.
-d
(Install HBA Driver, All Adapters)
To install an HBA driver for all iSCSI HBAs on the system from a .zip or .inf
file, enter the -d command as follows:
-d <File Name>
A system reboot may be required; see the log file for details.
NOTE:
This command is not active for the PPC.