Filter
Top Products
4 – Interactive Mode Commands
Port Level Info & Operations Menu
SN0054621-00 E 4-19
A
Port Level Info & Operations Menu
The Port Level Info & Operations Menu provides the following options:
1. Port Link Settings (see page 4-19)
2. Port Network Settings Menu (see page 4-20)
3. Edit Configured Port Settings Menu (see page 4-22)
4. Port Restore Factory Defaults (see page 4-28)
5. Port Diagnostic Menu (see page 4-29)
6. BIOS/UEFI Settings Menu (see page 4-34)
7. ---> Target Level Info & Operations (see page 4-36)
8. Select HBA Port (see page 4-49)
9. Refresh (see page 4-49)
10. Exit (see page 4-50)
On each submenu, save the changes by typing the number for the Save changes
and reset HBA option, and then pressing ENTER. This saves your changes and
resets all ports on the HBA.
To update the firmware with these changes, type the number for the Refresh
option, and then press ENTER. If you do not select this option, your changes will
not be visible in SANsurfer iSCSI HBA CLI.
Port Link Settings Menu
Select the Port Link Settings Menu option to open the Port Link Configuration
Menu containing the following options:
1. Display Active Link Configuration (see page 4-19)
2. Display Configured Link Configuration (see page 4-20)
3. Configure Link Configuration (see page 4-20)
4. Save changes and reset HBA (if necessary) (see page 4-20)
5. Select HBA Port (see page 4-49)
6. Refresh (see page 4-49)
7. Exit (see page 4-50)
Display Active Link Configuration
Select the Display Active Link Configuration option to view the following
information about the active link:
Connection type : (Copper or Fiber)
Portal Duplex : (Half-duplex, Full-duplex, or Disabled)
Portal Flow Control : (on or off)
Portal Link speed : (in Mbs)