Filter
Top Products
A – Port- and HBA-level Parameters
Port-level Parameters
A-2 SN0054621-00 E
S
AFW_Serlz_Task_Mngmt
on, off AFWSTM When enabled, the firmware will serialize all
Immediate task management function requests
(SCSI) such that only one Immediate task man-
agement command is outstanding to the target
at a time.
Default_IPv6_Router IPv6
address
IPRR IPv6 address format
DefaultTime2Retain
a
0–65535
seconds
n/a This parameter indicates the maximum logout
time (in seconds) the HBA uses when negotiat-
ing with a target device during login.
DefaultTime2Wait
a
0–65535
seconds
n/a This parameter indicates the minimum logout
time (in seconds) the HBA uses when negotiat-
ing with a target device during login.
Enable_4022IPv4 on, off E4022IPV4 Enables use of IPv4 on a 4022 board (applies to
405x and 406x HBAs).
Enable_IPv4 on, off EIPV4 Enables use of IPv4
Enable_IPv6 on, off EIPV6 Enables use of IPv6
ExeThrottle 0–32767 ET Specifies the execution throttle value. The exe-
cution throttle is used by the firmware to limit the
number of concurrently executing commands.
FirstBurstLen 0–3267
units
FB Indicates the maximum length for unsolicited
data. The HBA uses this information when nego-
tiating with a target device during login. This
parameter indicates how many units
(512 bytes/unit) of unsolicited data the HBA can
send/receive. A value of 0 indicates unlimited
data units.
Force_Negotiate_Main_
iSCSI_Keys
on, off FNMIK 405x and 406x only. iSCSI keys (defined in
iSCSI spec) that targets are forced to negotiate.
FW_Accept_AEN
a
on, off n/a When on and the HBA is a target, generates an
asynchronous target device database change
when a new connection is accepted.
FW_Access_Control
a
on, off n/a When on, the HBA will not enter iSCSI full- fea-
ture mode with an initiator until the target driver
authorizes the initiator.
Table A-1. Port Settings (Continued)
Parameter Value Alias Description