Filter
Top Products
A – Port- and HBA-level Parameters
Port-level Parameters
SN0054621-00 E A-5
A
IPv6_Nagle on, off TCPV6ND When enabled, the firmware uses the Nagle
algorithm. When disabled, the firmware disables
the Nagle algorithm. (For a description of the
Nagle algorithm, see RFC 896—Congestion
Control in IP/TCP Internetworks.)
IPv6_ND_Reachable_
Timer
0–42949
67295
b
IPV6NDRT Specifies the time (in milliseconds) that a node
assumes that the neighbor is reachable after
confirmation. The configured value will be over-
written if an updated value is received in a router
advertisement.
IPv6_ND_Retransmit_
Timer
0–42949
67295
b
IPV6NDRET Specifies the time (in milliseconds) between
retransmitted neighbor solicitation messages.
The configured value will be overwritten if an
updated value is received in a router advertise-
ment.
IPv6_ND_Stale_Timeout 0–42949
67295
b
IPV6STO Specifies the time (in milliseconds) after which a
stale IPv6 neighbor cache entry is discarded.
IPv6_Port 0–65535 IPV6PORT Specifies the default iSCSI target TCP port num-
ber for IPv6 connections.
IPv6_Redirect_Enable on, off PV6RDE When enabled and neighbor advertisements are
received, the connection table is examined and
updated if any active connections match the IP
address on the neighbor advertisement. This
action is required for failover and redirect. A
MAC address changed asynchronous event
(801Bh) is issued. When disabled, the NCB
table is not modified. No asynchronous event is
issued.
IPv6_TCP_Time_Stamp on, off TCPV6TST When this bit is set, the firmware negotiates to
use time stamps in TCP headers. When this bit
is cleared, the firmware does not use time
stamps in TCP headers.
Table A-1. Port Settings (Continued)
Parameter Value Alias Description