Filter
Top Products
4 – Interactive Mode Commands
Port Level Info & Operations Menu
SN0054621-00 E 4-25
A
Each setting is displayed with the current value in brackets, for example:
iSCSI_Snack [off] :
To change the value, type the new value after the prompt. To keep the current
value, press ENTER at the prompt. The next iSCSI setting appears. The settings
are shown one by one, in the order shown in the preceding list.
Table A-1 on page A-1 describes these settings.
Configure Firmware Settings
Use the Configure Firmware Settings option to modify the following firmware
settings:
FW_ZIO_Enable_Mode
AFW_Device_Timeout
AFW_Delayed_Ack
AFW_AutoConnect
Each setting is displayed with the current value in brackets, for example:
AFW_Device_Timeout [on] :
To change the value, type the new value after the prompt. To keep the current
value, press ENTER at the prompt. The next firmware setting appears. The
settings are displayed one-by-one, in the order shown in the preceding list.
Table A-1 on page A-1 describes these settings.
Configure Device Settings
Select the Configure Device Settings option to modify the following device
settings:
Large_Frames
ExeThrottle
FirstBurstLen
KeepAliveTO
MAXBurstLen
MAXOutstandingR2T
IPv4TOS
IPv4TTL
Each setting is displayed with the current value in brackets, for example:
FirstBurstLen [256] :
To change the value, type the new value after the prompt. To keep the current
value, press ENTER at the prompt. SANsurfer iSCSI HBA CLI displays the next
device setting. The settings are displayed one by one, in the order shown in the
preceding list.
Table A-1 on page A-1 describes these settings.