Filter
Top Products
5 – Non-Interactive Mode Commands
Non-interactive Commands
5-24 SN0054621-00 E
S
-pad
To view all targets for a port, enter the -pad commands as follows:
-pad <hba_port_inst>
-pb
(Bind Target)
Enter the -pb command to bind a target (make it persistent):
-pb <hba_port_inst> <Target ID>
For information on the interactive version of this command, see “Bind Target (CLI
Option -pb)” on page 4-39.
-pbootcode
(Set Primary Boot Target Information)
To set the primary bootcode boot target and LUN, enter the -pbootcode
command as follows:
-pbootcode <hba_port_inst> <tgt> <lun>
This command is not active for the PPC.
For information on the interactive version of this command see “Set Primary Boot
Target Information (CLI Option -pbootcode)” on page 4-35.
For information on secondary boot code, see “-sbootcode (Set Secondary Boot
Target Information)” on page 5-29.
-pdt
To disable a target, enter the -pdt command as follows:
-pdt <hba_port_inst> <targetId>
-pet
To enable a target, enter the -pet command as follows:
-pet <hba_port_inst> <targetId>
-pinfo
(Port Information)
To view port information for the specified HBA, enter the -pinfo command as
follows:
-pinfo <hba_port_inst>
For information on the interactive version of this command see “Port Link Settings
Menu” on page 4-19.