Filter
Top Products
5 – Non-Interactive Mode Commands
Non-interactive Commands
SN0054621-00 E 5-9
A
-dr <hba_port_inst>
For information on the interactive version of this command, “Display Default
Router List (IPv6) (CLI Option -dr)” on page 4-33.
-dspchap
(Display a CHAP Table)
To view the CHAP table, enter the -dspchap command as follows:
-dspchap <hba_port_inst>
For information on the interactive version of this command, see “Display CHAP
Table (CLI Option -dspchap)” on page 4-41.
-dtdsp
(Display Discovered Targets)
To view the discovered targets that are not persistent, enter the -dtdsp
command as follows:
-dtdsp <hba_port_inst>
For information on the interactive version of this command, “Display Discovered
Targets” on page 4-45.
-dtdspa
(List Targets)
To view discovered targets, including persistent and non-persistent, enter the
-dtspa command as follows:
-dtspa <hba_port_inst>
For information on the interactive version of this command, “List Targets (CLI
Option -t)” on page 4-37.
-dtdupd
(Duplicate a Discovered Target)
To duplicate a discovered target that is not persistent, enter the -dtdupd
command as follows:
-dtupd <hba_port_inst> <target_instance>
To obtain the target instance, use the command “-dtdsp (Display Discovered
Targets)” on page 5-9.
A duplicate target is assigned a new iSCSI initiator ID (ISID) and can then be used
to create a redundant path.
For information on the interactive version of this command, “Duplicate a
Discovered Target” on page 4-46.