Filter
Top Products
5 – Non-Interactive Mode Commands
Non-interactive Commands
5-8 SN0054621-00 E
S
-df
To view the firmware properties, enter the -df command as follows:
-df <hba_port_inst>
SANsurfer iSCSI HBA CLI displays information about the HBA: model, serial
number, port number, iSCSI name, alias, IP address, instance number, and the
following firmware information:
FW information for instance
FW version
FW attribute
FW version 2
FW attribute 2
There is no corresponding command in the interactive menu.
-dp
Use the -dp command to pre-install an HBA driver specified from a .zip
or .inf file. This operation may be performed without an HBA installed in the
system.
You can specify the following actions:
p — Pre-install driver package (default)
i — Install driver package
u — Uninstall driver package
g — Get driver package path
You may also specify the following flags:
DRIVER_PACKAGE_FORCE
DRIVER_PACKAGE_LEGACY_MODE
DRIVER_PACKAGE_ONLY_IF_DEVICE_PRESENT
DRIVER_PACKAGE_REPAIR
DRIVER_PACKAGE_SILENT
You may need to reboot the system following this command. For details about the
success or failure of the driver update operation, view the trace log file (see
Appendix F Using Trace).
-dr
(Display Default Router List [IPv6 only])
The IPv6 default router list includes both the active default router and a short list
of other routers that advertised themselves as capable of acting as a default
router. The active default router always appears first in the list.
To view the default router list, enter the -dr command as follows: