Filter
Top Products
5 – Non-Interactive Mode Commands
Non-interactive Commands
SN0054621-00 E 5-11
A
-dtrema
(Remove Discovered Target)
To remove all non-persistent discovered targets, enter the -dtrema command as
follows:
-dtrema <hba_port_inst>
For information on the interactive version of this command, “Remove Discovered
Target” on page 4-46.
-dumpcore
(Retrieve FW Coredump Record)
To dump the RAM memory to a file name of your choice, enter the -dumpcore
command as follows:
-dumpcore <hba_port_inst> [File name]
For information on the interactive version of this command, see “Retrieve FW
Coredump Record (CLI Option -dumpcore)” on page 4-16.
-dumpnvram
(Retrieve FW Flash & NVRAM Record)
To dump the NVRAM to a file name of your choice, enter the -dumpnvram
command as follows:
-dumpnvram <hba_port_inst> [File name]
For information on the interactive version of this command, “Retrieve FW Flash &
NVRAM Record (CLI Option -dumpnvram)” on page 4-15.
-dv
To see the version of the iSCSI HBA driver(s) installed, enter the -dv command
as follows.
-dv
There is no corresponding command in the interactive menu; however, you can
use this interactive option to view the current driver version: “Install HBA Driver, All
Adapters (CLI Option -d)” on page 4-11.
-edchap
(Edit a CHAP Entry)
To change the value of the specified CHAP entry, enter the -edchap command
as follows:
-edchap <hba_port_inst> <CHAP> <Parameter> | <Parameter Alias>
<Value> [<Parameter> | <Parameter Alias> <Value> …]