Filter
Top Products
4 – Interactive Mode Commands
Port Level Info & Operations Menu
4-20 SN0054621-00 E
S
Display Configured Link Configuration
(CLI Option -lcd)
Select the Display Configured Link Configuration option to view the following
information about the configured link:
Portal Flow Control : (on or off)
Auto-negotiate link speed: (on or off)
Link Speed : (in Mbs)
Configure Link Configuration
(CLI Option -lc)
Select the Configure Link Configuration option to view and modify each of the
configurable link settings, including:
Auto-negotiate link speed
Flow Control
The current setting (on or off) is shown in brackets. To change a setting, type on
or off, and then press ENTER.
Save Changes and Reset HBA (if necessary)
Before resetting the HBA, ensure no connections are active. Select the Save
Changes and Reset HBA option to save your changes and reset all ports on the
HBA.
Port Network Settings Menu
The Port Network Settings Menu options include the following:
1. Display Network Settings (see page 4-20)
2. Configure IP Settings (see page 4-21)
3. iSNS Settings (see page 4-21)
4. Select HBA Port (see page 4-49)
5. Save Changes and Reset HBA (see page 4-18)
6. Refresh (see page 4-49)
7. Exit (see page 4-50)
Display Network Settings
(CLI Options -netconf)
Select the Display Network Settings option to view the settings for dynamic host
configuration protocol (DHCP), link local address, IPv6, and iSNS. For example:
Using DHCP to obtain an IP Addresses.
IPv4 Address : 10.14.65.19
Gateway : 10.14.64.1
Subnet Mask : 255.255.254.0