Filter
Top Products
14.1 <
Installing accessories>
14 Installing accessories
Your machine is a full-featured model that has been optimized to meet
most of your printing needs. Recognizing that each user may have
different requirements, however, Samsung makes several accessories
available to enhance your machine’s capabilities.
This chapter includes:
• Precautions to take when installing accessories
• Installing a memory module
• Replacing the Stapler
• Enabling Fax feature after installing the fax option kit
Precautions to take when installing accessories
Disconnect the power cord
Never remove the control board cover while the power is being supplied on.
To avoid the possibility of an electrical shock, always disconnect the
power cord when installing or removing ANY internal or external
accessories.
Discharge static electricity
The control board and internal accessories (network interface or DIMM) are
sensitive to static electricity. Before installing or removing any internal
accessories, discharge static electricity from your body by touching
something metal, such as the metal back plate on any device plugged into a
grounded power source. If you walk round before finishing the installation,
repeat this procedure to discharge any static electricity again.
Installing a memory module
Your machine has a dual in-line memory module (DIMM) slot. Use this
memory module slot to install additional memory.
The order information is provided for optional memory
module
. (Page 13.1)
1 Turn the machine off and unplug all cables from the machine.
2 Open the control board cover by grasping it and slide toward you.
3 Take out a new memory module from the plastic bag.
4 Holding the memory module by the edges, align the memory
module on the slot at about a 30-degree tilt. Make sure that the
notches of the module and the grooves on the slot fit each other.
5 Press the memory module into the slot with care until you hear a
'click'.
Note
The notches and grooves illustrated above may not match
those on an actual DIMM and its slot.
6 Replace the control board cover.
7 Reconnect the power cord and printer cable, and turn the machine
on.
1
control board cover
1