Filter
Top Products
7.8 <
Scanning>
6 Select the index number from 1 to 20.
7 Enter a name in Alias for the Setup for the corresponding Server
List entry. This name will be displayed on your machine.
8 Select IP Address or Host Name.
9 Enter the server address in dotted decimal notation or a host name.
10 Enter the server port number, from 1 to 65535.
The default port number is 139.
11 Enter the share name of the server.
12 Put a check mark next to in Anonymous if you want to allow the
SMB server to be accessed by unauthorized persons.
By default, this is unchecked.
13 Enter the login name and password.
14 Enter the domain name of the SMB server.
15 Enter the location for storing the scanned image. This is the location
you entered in step 7.
16 Click Apply.
Scanning and sending to SMB/FTP server
1 Place the originals face up in the DADF. Or you can use the scanner
glass for one sheet of paper.
1 Press Scan to Server from the Main screen.
Note
If the authentication message shows, enter User Name
and Password. This message shows only when the network
administrator has set the authentication in SyncThru Web
Service. (Page 11.9)
2 Adjust the document settings in the Image tab.
3 Select Duplex and Resolution in the Basic tab.
4 Press SMB or FTP and select the server from the server list you
entered in the SyncThru Web Service. .
Note
You can select up to five destinations using both of SMB or
FTP servers.
5 Press Start on the control panel.
The machine begins scanning and then sends the scanned image to
the specified server.