Filter
Top Products
237
Open the Top Cover
1
Grasp the Top Cover Release
Lever to open the Top Cover.
NOTE:
If a problem with the Record-
ing Unit remains after this
action, you may require a
new developer assembly or
drum unit.
Check for dirt or paper un-
der the developer assembly
(with drum unit) first. Call
your service representative
for assistance.
Remove the
Developer Assembly
(with Drum Unit)
2
Recording Unit Cleaning Procedure
When the Recorded Image is not Clear... - continued
Wipe the glass surface of the
laser unit with a soft dry cloth
(lens cleaner cloth).
Remove the Developer Assem-
bly (with the Drum Unit at-
tached).
IMPORTANT:
• Never touch the photo-
conductive drum (the
green surface) of the
Drum Unit. If the surface
is scarred or scratched,
it will cause print quality
problems.
• Do not expose the pho-
toconductive drum of
the Drum Unit to light for
more than 3 minutes. If
the Drum Unit is to be
left anywhere outside
the facsimile, be certain
to cover it with cloth, pa-
per, etc.
Clean the Transfer Wire and
Discharge Wire with a cotton
swab.
CAUTION:
Do not touch the Transfer
Wire and Discharge Wire
with your hands. The oils
from your hands could con-
taminate the wire resulting
in lower print quality.
Clean the Paper
Guide
5
Wipe the Paper Guide with a
dry cloth.
Clean the Transfer
Wire and Discharge
Wire
4
Top Cover
Release Lever
Developer
Assembly
Glass
037
051
105
103-1
104
Wipe the Glass
Surface of Laser Unit
3