7-33
Setup Menus
Report Maximum Line Length
Factory default: 0
The setting of this option determines the maximum number of characters per line for
reports sent to the host. The numeric value must be in the range 0 through 65535.
This feature is disabled if 0 is specified.
Bypass Cancel Character
Factory default: ^J (LF)
This option sets the bypass mode cancellation character. Bypass mode is entered
when TeemTalk sends a report to the host so as to prevent reports echoed by the host
being actioned by TeemTalk. All characters subsequently received from the host are
discarded until the terminal receives the bypass cancel character, after which it
resumes processing received data.
If the host does not echo, then bypass mode can be disabled by specifying the
character as NULL (ASCII decimal 00) in one of the ways described in the following
paragraphs. Otherwise, set the bypass character to the last character that the host
sends when it echoes a line of text.
To change the current definition, delete the definition displayed in the text box and
type in the new one, either as the control key character equivalent or the decimal
value of the ASCII character. For example, the default ASCII character LF can be
entered by typing the characters ^ and J, representing the keys Ctrl + J which, when
pressed together would generate the LF code.
Decimal values are entered as three-digit numbers immediately preceded by an
underscore character. Values with only two digits must be preceded by a zero. For
example, the decimal value of LF is 10, so this would be entered as _010. Refer to
the ASCII character table in the Character Sets appendix for code and decimal
references.
End Of Line Characters
Factory default: ^M (CR)
This option is used to specify up to two ASCII characters in the decimal range 0
through 127 which are sent by TeemTalk at the end of reports sent to the host.
To change the current definition, delete the definition displayed in the text box and
type in the new one, either as the control key character equivalent or the decimal
value of the ASCII character. For example, the default character CR can be entered
by typing the characters ^ and M, representing the keys Ctrl + M which, when
pressed together would generate the CR code.
Decimal values are entered as three-digit numbers immediately preceded by an
underscore character. Values with only two digits must be preceded by a zero. For
example, the decimal value of CR is 13, so this would be entered as _013. Refer to
the ASCII character table in the Character Sets appendix for code and decimal
references.