Xerox -05W Printer User Manual


 
E-1
Host Command Summary
E
Host Command Summary
This appendix lists the host and Tek Primary Setup commands that are
valid in each terminal emulation mode. TeemTalk-specific commands
are listed at the back.
The following conventions are used in this command list:
Spaces in a command are for clarity only and are not to be entered as part of the
command. A space character that is part of the command will be shown as SP.
An asterisk (*) in a command indicates the location of one or more parameters
except otherwise indicated next to the command.
VT52 Mode
CHARACTER SET SELECTION HOST PRIMARY SETUP
Invoke G0 character set SI
Invoke G1 character set SO
Select G0 character set ESC G
Select Line Drawing character set ESC F
CURSOR HOST PRIMARY SETUP
Direct cursor addressing (1 to 96 = SP to DEL) ESC Y *line *column
Insert FF character & advance cursor FF
Line feed LF
Move cursor down one line ESC B
Move cursor down one line VT
Move cursor home ESC H
Move cursor one column left BS
Move cursor one column left ESC D
Move cursor one column right ESC C
Move cursor to left margin of current line CR
Move cursor to next tab stop HT
Move cursor up one line ESC A
Reverse line feed ESC I