Filter
Top Products
7-34
Setup Menus
End Of Message Characters
Factory default: ^M (CR) and ^J (LF)
This option is used to specify up to two ASCII characters in the decimal range 0
through 127 which are sent by TeemTalk to end a line of data transmission.
To change the current definition, delete the definition displayed in the text box and
type in the new one, either as the control key character equivalent or the decimal
value of the ASCII character. For example, the ASCII character LF can be entered by
typing the characters ^ and J, representing the keys Ctrl + J which, when pressed
together would generate the LF code.
Decimal values are entered as three-digit numbers immediately preceded by an
underscore character. Values with only two digits must be preceded by a zero. For
example, the decimal value of LF is 10, so this would be entered as _010. Refer to
the ASCII character table in the Character Sets appendix for code and decimal
references.
EOM Frequency
Factory default: High
The end of message frequency specifies how often TeemTalk inserts end of line strings
into reports that it sends to the host.
Terminal
Factory default: 4207
The setting of this option determines the extent of control over text displayed in the
graphics area. Specifying 4105 will cause the Tek emulation to use string precision
text only, whereas 4207 or 4111 (depending on your version of TeemTalk) will allow
both string and stroke precision text. String precision text only consists of alpha
mode fonts. Stroke precision allows both alpha and user-defined fonts to be
displayed, and provides greater precision when slanting, rotating or sizing the text.
Answerback String
This option enables you to specify the Answerback string that is sent to the host in
response to an ANSI mode enquiry command. The string may be up to 30 characters
long.
Answerback Concealed
Factory default: Unselected
Selecting this option will cause the Answerback string specified in the text box above
to be locked from change and displayed as asterisks. Note that deselecting this option
will cause the Answerback string to be deleted.